May 24
A clean (relatively) work table
Today, yes, I’m throwing stuff out, but it is a little bit more rag-tag than usual. However, it has done more good that most of the days of this project. Today, I cleared off my work table.
Get Lance Clarke’s stories in your inbox
Join Medium for free to get updates from this writer.
Sadly, I never seem to take a before picture at the start of such projects, but suffice it to say, you couldn’t see very much table, and what you could see wasn’t on the table top! However, I did take the after picture, and here it is:
Key to this cleanup was the organization of my screws. You can see the labled drawers in the blue organizer. Most of those now hold screws that were in the original packages that took up bits of my table an the entire top of the organizer. It was hard to find the size I needed when I needed it, and often I ended up buying sizes that I already had.
I’ll continue the labeling project as I continue. You can see the screw packages that I emptied out below. Also seen are containers, a towel and various little bits that I know I really don’t need.
Included are quite a few screws or bolts that are in sizes that are not ever needed, rusty screws, and most of all screws that are cheap or use Phillips or slot heads.
Hopefully the result of this will be a workshop that is more useable. I spend a lot of time in my workshop, but mostly it has been picking my way through the maze on the floor to try to get to my computer. Now all I have to do is keep the table neat and finish the job in the rest of the room.










