Wood Frame
To end last week’s experiment, Edward and I decided to test on how latex would react to different wire thickness and also on wooden frames, in this case plywood. With the help of Peter and Vincent, we were able to make a few experiments.
To start, we stretched the latex 120% from the original size and attached it to a 1.66 mm armature wire.
To our surprise, the latex didn’t warp just like our previous experiments and it also didn’t rip during the process. Despite the fact that the wire used is pretty flexible and malleable, the latex is still in its original shape. Afterwards, we continue experimenting using the 1.66 mm wire but this time with a 150% stretch. The result is still the same with it not warping at all. However, we noticed a few line marks on the latex. What we observe from these experiments is that the thickness of the wire does have an effect to the latex.
Get Sarah Xaviera’s stories in your inbox
Join Medium for free to get updates from this writer.
For our next series of experiments, we tested on how wooden frames impact the shape of the latex. We tested out with plywood frames of different thickness and using latex with different stretching percentage. The first test we made came out pretty successful just like the wire since it doesn’t warp the latex. The other two experiments coming afterwards also came out successful showing that using plywood frame with around 5 mm thickness works well with the latex at any stretching percentage.
However, after a few minutes, we noticed that for the first experiment,a part of the latex became detached from the frame. But from what we observe, the detachment was caused by the amount of glue applied on that area.
Patterns
Since we have been testing on only plain square wires and plywood frame so far, Edward and I were thinking of patterns that could become the structure for the latex. For further experiments, we need to look at how patterns can affect the shape of the latex and how it can optimize its performance.








