Display your 150mm photolithography masks in style with the Litho Light! Watch the video here.
Read online: https://github.com/mattvenn/litho-light/
- Plug in the right angle USBC cable. Turn the power on with the power switch.
- Set the brightness to the lowest level with the brightness control.
- Press the mode button to cycle through the light modes:
- RGB colours (recommended),
- Effects,
- White.
- Adjust the colour / saturation with by pressing the adjust slider up or down.
- In RGB colour mode, to switch between colour and saturation press the adjust slider in.
- The light is a SmallRig P96L.
- The provided cable is a UGREEN right angle USB A to USB C. If using a different cable, check it has clearance to fit.
- The housing is 3D printed from this CAD.
- The main housing STL (30% infill, black PLA)
- The diffuser bezel STL (15% infill, black PLA)
- The diffusor is 2 sheets of tracing paper held in place with the bezel.
- Thanks to Adam Zeloof for assistance with the CAD.
- Thanks to IHP for the mask. Watch this to find out more about how masks are used to create microchips.
- This project is licensed under the Creative Commons Attribution Sharealike 4.0
- Photo gallery