Make a splint using some duct tape and spare thin wood parts (or grab a few branches from a tree). That will tide you over until you get tired of looking at an ugly broom and buy a new broom stick.
Gorilla glue it back together. Then gorilla glue a full length splint onto it. Then use several screws to screw the original handle to the splint. I once fixed a futon frame this way.
Well if he’s going that far, may as well go get a lathe from market place, then find an appropriate hardwood block. He can lathe the block into a nice cylinder, making sure grain of the wood runs in the same direction (lengthwise). Then use the center drill action on the lathe to carve out the exact diameter of the broomstick. Then he can jam the broken pieces into it with some 3x strength wood glue.
It should hold until he wants to replace the broomstick in 20-30 years.
Just detach the broom head and get a pvc pipe of appropriate length and diameter. Cap the end that points toward you, gorilla glue the broom head onto the new stick/handle.
Detach and measure the broom head’s ‘socket’ before you go to Home Depot.
My car snow brush head came off the handle the one day, I found that the screw had absolutely no threading and promptly lost the screw anyway. Easiest solution was taking a nail longer than the diameter of the handle, curving it into an L, inserting it and wrapping the thing in duct tape. Worked great!
Make a splint using some duct tape and spare thin wood parts (or grab a few branches from a tree). That will tide you over until you get tired of looking at an ugly broom and buy a new broom stick.
Gorilla glue it back together. Then gorilla glue a full length splint onto it. Then use several screws to screw the original handle to the splint. I once fixed a futon frame this way.
Well if he’s going that far, may as well go get a lathe from market place, then find an appropriate hardwood block. He can lathe the block into a nice cylinder, making sure grain of the wood runs in the same direction (lengthwise). Then use the center drill action on the lathe to carve out the exact diameter of the broomstick. Then he can jam the broken pieces into it with some 3x strength wood glue.
It should hold until he wants to replace the broomstick in 20-30 years.
Yes! How did you know I will use just about any excuse to buy new tools?
That sounds more expensive though. But ideally yes.
get a lathe? get a lathe. well lah dih dah mr french man look who doesn’t take the opportunity to make a rudimentary lathe at the drop of a hat
Alternatively:
Just detach the broom head and get a pvc pipe of appropriate length and diameter. Cap the end that points toward you, gorilla glue the broom head onto the new stick/handle.
Detach and measure the broom head’s ‘socket’ before you go to Home Depot.
My car snow brush head came off the handle the one day, I found that the screw had absolutely no threading and promptly lost the screw anyway. Easiest solution was taking a nail longer than the diameter of the handle, curving it into an L, inserting it and wrapping the thing in duct tape. Worked great!
you can stick a dowel inside the hollow bit, glue it in place. splint it from the inside.
that repair could last until you get a new broom