EKINSUN·3h agoIt Starts for a Turn — Then It JamsSame-diameter coarse and fine threads are not interchangeable. Here is why the joint feels almost right, and why more torque ruins both…
EKINSUN·1d agoCopper or Aluminium Is Not a Material Callout“Custom aluminium heat sink, 80 × 80 mm” describes a problem. It does not describe a part. The shop still has to guess which alloy you…
EKINSUN·2d agoThe Catalogue Nut Is M120×4. The Shaft Is M120×3.ISO 261 still lists the 3 mm pitch. Ten crests on a steel rule will tell you whether the shelf part will go on.
EKINSUN·3d agoBuy the BSP-to-NPT Adapter Off the Shelf When It ExistsCommon pairs up to about 1 inch are catalogue parts. Here is when to buy the stock fitting, and when a one-off is actually justified.
EKINSUN·4d agoA Part Number Is Not a Drop-In ReplacementThe shortest request in this kind of work is also the least usable: “Please make an equivalent of the OEM part.” Sometimes there is a…
EKINSUN·5d agoDon’t Order a Thread Adapter With Just Two NamesAn enquiry that says only “M20 to 3/4–16 adapter”, or “BSP to NPT, 1/2 inch”, describes a mismatch. It does not describe a part. The shop…
EKINSUN·6d agoThe Title Block Says ISO 2768-mK. That Is Not a Fit.The general-tolerance note tells a shop what unmarked sizes may do. It does not tell a bearing, a bolt pattern or a thread what to do.
EKINSUN·Nov 14The Standard Hex Is Not Always the Right HexA maintenance engineer can order the right diameter and still receive a nut that will not start on the shaft. The label said M120. The…
EKINSUN·Nov 13Measure What Didn’t Wear: Remaking a Part the OEM DroppedA worn sample is evidence, not a specification. Here is how engineers turn one into a part that actually fits.